Parallels remote desktop use local printer osx

PARALLELS REMOTE DESKTOP USE LOCAL PRINTER OSX INSTALL
PARALLELS REMOTE DESKTOP USE LOCAL PRINTER OSX DRIVERS

If the printer does not print then open the printer properties on the Remote Desktop connected computer and change the port to TS002: on the Ports tab, click Apply then click вЂњPrint a test pageвЂќ on the General tab to test again.

Test the printer by clicking on вЂњPrint a test pageвЂќ then click the Finish button.

Choose вЂњDo not share this printerвЂќ and click on the Next button.

Change the name as needed and click on the Next button.

If requested, choose to вЂњReplace the current driverвЂќ and click on the Next button.

PARALLELS REMOTE DESKTOP USE LOCAL PRINTER OSX DRIVERS

Search through the list of drivers to pick the one associated with the one being connected then click on the Next button.Click on the list вЂњUse an existing portвЂќ and choose вЂњTS001:вЂќ which usually corresponds to the LPT1: port redirection, but it may take some trial and error going through this list later to figure out which one it is.Click on the radio selection next to вЂњAdd a local printer or network printer with manual settingsвЂќ then click on the next button.Click on the Add Printer button at the top then click on the вЂњThe printer that I want isnвЂ™t listedвЂќ link at the bottom of the window that opens.

Inside the Remote Desktop connected computer click on the Start button and open Control Panel then open вЂњDevices and PrinterвЂќ.

PARALLELS REMOTE DESKTOP USE LOCAL PRINTER OSX INSTALL

Once connected download and install the needed print driver but do not create the printer itself yet.Make sure to go back to the General tab and click on save before clicking on the Connect button.Click on the вЂњMoreвЂ¦вЂќ button at the bottom then put a check next to the Ports item then click the OK button.Click on the Start button and open Remote Desktop Connection then click on the вЂњLocal ResourcesвЂќ tab.Click on the Ports tab and put a check next to вЂњEnable printer poolingвЂќ and next to the вЂњLPT1:вЂќ in the list then click the OK button to finish.Right click on the network printer that needs to be redirected and choose вЂњPrinter PropertiesвЂќ.Click on the Start button and open Control Panel then open вЂњDevices and PrintersвЂќ.Found this little workaround to provide Remote Desktop network printer redirection in the Microsoft forums: Remote Desktop network printer redirection workaround Found out later indeed they were not able to use the printer successfully due to the inherent issue with network printers across a Remote Desktop Connection. Even after successfully getting them connected to the local workstation and warning them there would be issues with using their network printer at the remote office, they stated it would be just fine. Found myself setting up a client with a remote desktop connection to a local workstation from a remote site to use their Client Management System (CMS).

Parallels remote desktop use local printer osx